With Co-editor, Steve enjoying a short tour of Belgium, I've been busily harvesting kit, while weaving rest and play into the mix. I also fitted these Coefficient The Wave Handlebars, to my Holdsworth.
Described as "The Ultimate Road, Gravel & Endurance Handlebar"; its a curly carbon fibre design. One that bears passing resemblance to Genetic D-Riser 16 https://www.sevendaycyclist.com/genetic-d-riser-bars and to a lesser extent, Soma Condor 2 https://www.sevendaycyclist.com/soma-condor-2-shallow-drop-bars
In common with these aluminium alloy models, the wave is reckoned an ergonomic design for riders seeking "The speed of drops, and the long ride comfort of the bar tops". Apparently, the sloping top section provides a hand position mimicking the wrist's natural alignment.
A slight, 1.5 degree flare reputedly offers a more solid stance, meaning you can remain on the drops for longer, even off road. The grip diameter varies proportionately, to reflect different hand sizes
Some traditional drop features remain, including 77mm reach and 120mm drop. I've gone for the 44cm, which would seem the best fit, given I'm broader across the shoulders than my height and build would otherwise imply.
Fully compatible with Di2, there's the option of routing brake and gear cables internally. However, they can be run and taped beneath the bars, as I have here. I've reused the Holdsworth's silicone bar wrap, which also compliments the bars' matt black finish rather well.
Some folks might be tempted to bolt tri bars atop. Don't! To some extent this would detract from pattern's unique selling points but more importantly, doing so runs the very real risk of potentially fatal, structural damage. Since we're here, maximum recommended torque settings are 6nms.
Forgo torque wrench at your peril.
My maiden voyage confirmed I needed to move the bike's Tektro brake lever down a few centimetres but some 220 miles in, I'm suitably smitten. There's sensible scope for torch type lights, computers and similar creature comforts, too.
Given carbon composites should be more readily inspected for signs of fatigue, a naturally grippy, reusable wrap, such as this ACROS Silicone Wrap Handlebar Tape https://www.sevendaycyclist.com/acros-silicone-wrap-handlebar-tape is an obvious choice. Its also rather nice, in its own right.
Low weight and wow factor are two obvious draws to carbon but while I wouldn't entertain touring on a carbon frameset (even with a YAK type trailer trundling behind) its nice for other genres of endurance riding.
Compliance reduces fatigue, especially on longer rides. Said bar swap has shaved 130g but has introduced a more compliant feel to the Holdsworth's front end. On paper, it shouldn't feel that way, given the 531 tubes and carbon composite blades but large flange hubs and relatively deep section rims give a brisk, though slightly direct ride.
The Coefficient Wave are springy, compared with the otherwise loveable Soma and its quite noticable (though not unpleasant or unsettling) when powering along a climb, from a junction etc.
Carbon fibre is also very conductive, so when it comes to frames, remember to grease the aluminium alloy bottom bracket sleeve liberally, using an appropriate prep. Assuming of course, you wanted to avert galvanic seizures. White Lightning Crystal High Performance Grease https://www.sevendaycyclist.com/white-lightning-crystal-grease or Muc Off Bio Grease (which could easily pass for strawberry jam) https://www.sevendaycyclist.com/muc-off-bio-grease-long-term-test seem effective.
Contrary to popular misconception, carbon composite frames are repairable, even when seemingly beyond redemption. That said; this is only economically viable, on high-end, rather than budget variants. They can also be refinished using 2k automotive paints and either air, or flash cured at 120 degrees. Had a mishap? Have a word with Carbon Fibre Repair in Leatherhead, Surrey. https://www.sevendaycyclist.com/a-visit-to-carbon-fibre-bike-repair
Summer jerseys have become not only lighter, but longer and er, tighter, I mean figure hugging. Thus far, I've only felt the benefits in terms of improved temperature regulation, and indeed, reduced drag. I've only been able to measure this anecdotally (being bereft of wind tunnel facilities) but there's markedly less flutter when hustling along breezy backroads, and screaming along the descents.
Even with the zipper drawn to half-mast, for additional, physical airflow. This thinner, second skin close genre aren't the most accepting of Lycra arm warmers, base layers etc, which may be a turn off for early spring and Autumn duties. However, they translate well to indoor trainer slavery, I mean service, during the darker months.
Talking of which, I've also been doing some long, steady night miles with the Ravemen PR1200 USB Rechargeable Dual Lens Front Light https://www.facebook.com/sevenday.cyclist/videos/pcb.2109616222667497/2109613026001150/?type=3&theater We're also awaiting some rather nice Trelock lights. I'm keen to test another, higher power front dynamo lamp, for my fixed gear winter/trainer (100 lux upwards).
That said; I'm not overly keen on the German beam pattern as dictated by their StVZO/TA standards.Yes, there's no doubt it provides enough punch in the seen-by sense. However, on UK roads (Especially unlit ones) its less effective than my beloved Exposure MK1 Revo and indeed, high power rechargeable systems..
With Parliament (and some would argue, democracy) in meltdown, the late summer heatwave returned. What better opportunity to get some serious miles on the Holdsworth...
While fitting those new bars, I nipped the chain tension up a notch, ressurecting these MKS chain tugs, while I was about it.
Topped up the Zefal Extra Dry Premium Quality Chain Wax https://www.sevendaycyclist.com/zefal-extra-dry-chain-wax which returned 120 miles, before ultimately stripping with Naked Bikes Chain Cleaner https://www.sevendaycyclist.com/naked-bikes
I've since switched to Rock n' roll Gold LV. Despite some wet spells, the moderate helping delivered to my other chains, is still going very strong after 250miles.
So then, busted butyl. Well, while prepping my fixed gear winter trainer for a late night saunter and light test, the front wheel's presta valve literally disintegrated in my hand.
Undeterred, I switched to the Halo Evua And Shutter Precision SL9 Dynohub Wheel https://www.sevendaycyclist.com/halo-evura-shutter-precision-sl9-dy, whacked some wind in the Soma Shikoro tyre https://www.sevendaycyclist.com/s, and replaced the other tube, on my return. The old tube lives on, as a brace for my Nicotina plants, whicxh are doing rather well, all things considered...
