No sooner had I believed the fleet was sorted, Denise got jealous and rejected her bottom bracket. I discovered this while replacing her chain, which was reading close to .7 on the chain wear indicator. Two chains had just arrived, so no sense putting off the inevitable. After a fit of pique, I found an (unused) mountain bike bottom bracket within the transmission box, gave the non-drive side a liberal helping of Muc-Off Bio Grease TESTED : MUC-OFF BIO GREASE (sevendaycyclist.com), the drive side, Oxford Mint Assembly Grease. This was just to see how the two would compare, in a like for like context.
Since I had the cranks off, I stripped the axle and reached for the Peaty’s Speed Grease PEATY'S SPEED GREASE | cycling-not-racing (sevendaycyclist.com) which is palpably lower than most on the friction front and is surprisingly durable into the bargain. Even though the existing KMC wasn’t completely spent, the replacement translated in much snappier shifts, too.
Hopefully, that’s the last of the drivetrain consumables for a while, though. Depending on how rough winter plays, I’ll get 3-4 months from chains and at some point, I'll get another (XT grade) bottom bracket or two in, should something get the grumbles. Stuff usually goes pop at the least convenient moment, so keeping staples is good practice.
Ursula succumbed to the first post-rebuild flat- couldn't find anything inside the Continental’s tyre casing, having washed and scrubbed them as part of a more intense generic bike clean. The tube had a hole around the seam, so I switched to a fresh one and pondered whether I should patch or retire.
I seldom consign these to landfill since they make great chainstay protectors, headset boots etc. Denise’s lower race boot is proving highly effective at keeping the slime at bay. After some deliberation, I ultimately decided to go the former route with Ursula and placed some along the downtube, where the Ravemen XR6000 Ravemen XR6000 Front Light | cycling-not-racing (sevendaycyclist.com) battery rests.
Talking of batteries, I wasn’t getting any readout from the Giant computer, which basically boiled down to an exhausted CR2032 sensor battery. I’ve also tackled some alignment issues with the front Mudhugger guard and have decided to go the original rear Mudhugger route.
These are shorter than the MK2 and I didn’t feel the need for Velcro, since I’m unlikely to be removing them- just a question of liberally applying helicopter tape and some old tube atop that to rule out any paint damage, then pulling the cable ties very snug.
Another definite plus about the mud hugger and their gravel hugger cousins is both feel secure and rigid aboard the bike. The fixed gear winter/trainer’s hasn’t been touched, save for a replacement tie and yes, I also clean beneath the guards to prevent potentially abrasive and/or corrosive stuff building up. I took my time when fitting both, fitting things loosely, getting alignment spot on before pulling the cable ties snug. Talking of ties, the OEM are 3.6mm (about 0.14 in) thick-I’d lost a couple, so employed some slightly thinner examples as a meantime measure.
Otherwise, it's aesthetically much sleeker than the generally serviceable, if slightly whippy post mounted unit it replaces. Staying with mucky stuff, I’ve been getting plenty of miles aboard Denise and the 120tpi versions of the WTB Nano WTB Nano TCS Tyre | cycling-not-racing.
Though not wildly different to their 60tpi siblings, ride quality feels more compliant, and they feel slightly friskier, too. Too early to say whether the SC2 puncture repelling belt is superior and indeed, that of the Maxxis Ravager Maxxis Ravager TR Tyres | cycling-not-racing but there’s plenty of gloop around and winter’s cranking closer, so we’ll see.
The Madison DTE Men’s Isoler Thermal Long Sleeve Jacket continues to impress. Well, it’s a middleweight jersey by another name with a thin pile fleece lining to keep the chill out and a DWR waterproof coating. In common with similar garments, the latter should be thought of as resisting misty, light showery stuff and extending the time before you need to don a micro jacket/gilet, not battling rains of biblical proportions. The fit’s great, ditto the pocket layout and design.
While the Topeak Gravel Two-Stage Mini Pump Topeak Gravel 2 Stage Mini Pump | cycling-not-racing (sevendaycyclist.com) is a reliable staple, I’m leaning toward mini compressors for roadside rescues and CO2 inflators as a third, contingency option. Muc-Off has just sent me their Airmach electric mini-inflator. Its more compact than the CYCPLUS AS2 Pro Max Epump CycPlus AS2 Pro Max E.Pump | cycling-not-racing (sevendaycyclist.com) or indeed, the Fumpa FUMPA PUMP | cycling-not-racing (sevendaycyclist.com) which has its pros, obviously on the space front but I’ll reserve judgement for now, see how it performs in the real world.
Lighting continues to arrive, and I’ve just received this Ravemen K1800. As the name suggests, it’s another master blaster pumping out 1800 lumens. Probably the most notable feature is the AI technology, which allows the light to adjust output according to your riding style and environments. Theoretically, this will leave me free to enjoy the ride and get the best balance of performance and economy.
