Wouldn't You Know It

 

Having replenished the grease and attached the Ritchey WCS perch, I decided the USE Sumo post should sit pride of place in the fixed gear winter/trainer. Everything slid together effortlessly, thanks to the precision USE shim. I ported the Klick fix mount over the WCS rails, checked everything was at the correct height, correctly aligned and torqued before reattaching the Axiom City Plus. Talking of fitting and switching contact points, here’s my review of the Oxford Mint Assembly Grease Oxford Mint Assembly Grease | cycling-not-racing 

 

I needed to drop Denise's post by a few millimetres, since my leg was extended too far and quick dab downs were also less predictable. Timely too since I met a boisterous young Alsatian called “Cooper” off the lead and whose owners seemed casually disinterested. I was immediately reminded of Richard Ballantine’s remarks about dogs and other creatures of the field and air being a menace to the cyclist... 

 

Cooper eventually trotted off with the couple. I’d dismounted at this point, resting Denise against the tree by her bars, so no danger of being knocked off by a hound high on life. I’d been bitten by an Alsatian on two separate occasions during my adult life, so though not fearful, I’m very mindful. My silence was also a quiet contempt for the owners and their elected indifference.   

 

I stood reflecting on the 120tpi WTB Nano’s performance, relative to their 60tpi stablemates, my decision to drop the saddle height before heading out and my continued appreciation of the Gorewear C5 GORE-TEX Thermo Gloves. I’ve also switched over to Tubolite TPU tubes and decided I wanted greater cornering prowess, so switched the Shimano PD ED500 pedals Shimano PD ED 500 Pedals | cycling-not-racing for the Wellgo MO94B WELLGO MO94B SPD PEDALS | cycling-not-racing  which also represents a181g weight saving.  

 

Back in the saddle, I scooted off and hustled along the newly muddied lane and found myself concluding the Ergon SR All Road Core Comp Ergon SR All Road Core Comp Saddle Men | cycling-not-racing is genuinely more comfortable than the more basic (but still excellent) All Road Ergon SR All Road Men’s Saddle | cycling-not-racing  Other dogs and their owners were far more gracious, dare I say emotionally intelligent and received a suitably cordial greeting as we passed.  

 

Another thing I had been conscious of is some swaying of the Topeak Backloader. I’ve bund some old inner tube around the post with the hope of minimising any bob, or sway, while simultaneously protecting the USE SX posts’ anodised finish. Post mounted luggage of this kind is designed for bulky but crucially light loads and riders with any experience will mount heavier items low. I’ve followed this narrative, as you’d hope. I’ve stashed several tubes, Muc-Off Pump, small multi tool and CycPlus AS2 Pro Max E.Pump CycPlus AS2 Pro Max E.Pump | cycling-not-racing inflator which is well within the acceptable and indeed, maximum payload. Now, I’m quick to confirm this is minor sway, not samba dancing. Despite substantial Velcro closures, uber litre designs are prone to sway, due in part to length and their lofty position- the main reason I err away from them.  

 

Dynamos rule the roost when it comes to my four seasons’ bikes, but I always carry a compact rechargeable light as backing singer/backup. I was suitably impressed with Ravemen LR 1000Ravemen LR 1000 Curved Lens Front Light | cycling-not-racing and was curious about the brands K series. Enter the most powerful 1800lumen unit here. There are some obvious similarities with the LR1600, most obviously, the sensored technology. In this instance, its two tiered and incorporates AI (Artificial intelligence). The daytime running mode will select the intensity it feels appropriate, while the AI learns the lighting conditions on your routes and tailors things between 100 and 180-lumens accordingly.  

 

Obviously, the wireless remote means you’re not beholden and can override to taste. Then of course, there are the features we’ve come to expect from Ravemen. IPX7 for weatherproofing, solid CNC machined casing and the ability to charge phones and similar gizmos from the port and you can also plug in a power bank, should reserves dwindle. In common with some of the smaller LR family, I’m not completely taken with the mount.  

 

By no means poor, it's quick to whip on/off, which is convenient for commuting and other contexts where bikes can be unattended for periods of time. However, on balance I prefer the more substantial versions employing Allen keys common to the PR series and LR1600 Ravemen LR1600 Front Light | cycling-not-racing.          

       

What of the 120tpi Nano, then...Well, I’ve noticed their improved compliance over their otherwise likeable 60tpi counterparts, switching to a TPU tube up front has also brought some tangible benefits on the compliance front, especially at the higher end of their 50psi pressure range. The Nano aren’t intended for gloopy mud synonymous with a British, or indeed, Belgian winter cross meet but seem to behave in excellent proportion across moderate, greasy mud.  I'll close for now with my review of The MagicshineSeeMee100AD Radar Detection Tail Light Magicshine SeeMee 100 Tail Light | cycling-not-racing    

Frankensets

 

I’d continued to build Ursula in short, little and often bursts. I’d instated the Microshift bar con, replaced a tube in the rear Ryde XT wheel and inflated the Continental Cross Kings to 55psi and then began contemplating Ursula’s bar tape. Change for changes sake, a new era? I didn’t want to say goodbye to the Cycology 8 days Cycology 8 days Handlebar Tape | cycling-not-racing (sevendaycyclist.com) just yet, but fate (and the elements) had other ideas. I’ve gone for the Acros Silicone Bar Wrap LONG-TERM TEST: ACROS SILICONE BAR WRAP | cycling-not-racing (sevendaycyclist.com) the orange rather than blue, given winter’s looming. It's easily wrapped and naturally sticky, so no need for a backing adhesive, which makes cable swaps that bit easier.   

While I pondered this, my place in the Universe etc., I decided to install a fresh set of Microshift bar cons. There was nothing wrong with the original left shifter, but I decided since I needed to fit the rear bar con, I may as well go for uniformity at this stage. I want the rebuild right, from the off. Jagwire Road Elite sealed cables (173g complete and uncut) were also installed but fatigue left me convinced I’d a full set of derailleur cables. I had several inners but only one outer and one complete set of ferrules. I left everything snug but not pruned and decided to quit while ahead.   

The following day, I managed to whip the rear wheel in, set up the rear brake calliper and fitted a KMC chain, using the sleeping hub to hold everything in alignment. I’ll dial in the rear mech another time, probably when the front mech cable arrives. Meantime, I’ve popped the Acros tape (left side) into the wash.  All was going well until I tried the headset. Having stripped the Stronglight unit, I discovered it wasn’t all it seemed- a frankenset, made from bits of headsets. I had another, a cartridge model bought a while back and yep, despite being in a sealed envelope, was also missing parts. Bottom line, I was weary of wasting any more time, removed the Stronglight and bought an FSA, consigning the former to the bin.   

Elsewhere, the ORP Smart HornTESTED: ORP SMART HORN (sevendaycyclist.com) has returned to my fixed gear winter/trainer’s Genetic D-Riser 4 bars GENETIC DRISER 4 HANDLEBARS | cycling-not-racing (sevendaycyclist.com) The two-tone powder coat finish is enjoying its 9th birthday and is still in great shape. Though wet has been the primary narrative of the past fortnight, I found time to give the bike a seriously good clean, removed the seat post and blasted some of the waxy corrosion inhibitor inside.  I hung it up for a few days, switching to Denise for some fun along the lanes, allowing the fixed’s corrosion inhibitor to cure thoroughly.   

More lights have been coming our way-as you’d expect, given we’re entering the darker season. Magicshine See Mee 100AD Rear Light, which can produce, you guessed it, 100lumens. AD stands for Auto Detect, referring to the sensor system, which produces a more intense flashing light when it senses another vehicle approaching. It can also be synced with other compatible taillights for heightened presence.  

Not forgetting the Alty 800 V2.0/1200/1200U front lights. IPX6 for weatherproofing seems increasingly to be the default, which is good news for most consumers. It’s not waterproof in the submersible sense, but will certainly fend off very heavy rain, standing water, mud too, in my experience.  

I’ve not had too much issue with lights confirming to the lowlier IPX4 over the years- at least for road biased duties. However, there have been occasions when I’ve needed to flush a drowned unit out with a few liberal blasts of water displacer.  

Formative impressions suggest the See Mee 100AD sensor is very accurate and the flash deployed remarkably effective at grabbing and holding attention. Theoretically, this should mean being able to run a lower setting, conserving power and letting the intelligent technology do its thing when other vehicles approach.  

This doesn’t come naturally to me. Surrendering to tech’s mercy isn’t something that sits naturally with me but in the interests of testing. I’ll give it a go. The relatively flat lens design also aroused some minor concerns around peripheral presence, say when crossing junctions etc. but the projected light seems to counter this.  

Another nice feature is mount compatibility with others in the SeeMee family, so I can just switch places with the See Mee 50Mag, or indeed, the SeeMee100 and SeeMee 200 V2 without any issues. Super convenient and very welcome. It also makes sense from the vantage point of manufacturing economics.