Workhorse Worship

Having reached some definite conclusions about Muc-Off hydrodynamic chain lube, I wasted no time in introducing the Univega to its new chain, cassette and Genetic flare silicone handlebar wrap. Shimano’s HG50 (Tiagra by another name) requires little introduction and might be a little workmanlike by some standards. However, there’s a good rationale’ for running cheaper consumables on everyday/winter bikes and besides, it shifts pretty sweetly.

More interesting is the KMC X9 chain’s “Eco ProTeQ” anti-rust coating. KMC give little away, other to say it passes the 650 hour salt spray test but cursory inspection suggests it’s a form of nickel plating. Galvanised designs work well-to a point but once it’s worn through, they’ll turn orange at the merest lick from a slushy puddle.

The Ilpompino wasn’t left out either, courtesy of this perfectly coordinated, injection moulded Tacx Deva bottle cage, which is a composite in the true sense, comprising of 40% carbon fibre blended with glass fibre and polyamide. That curvaceous stainless steel Axiom cage still adorns its seat tube bosses as I like to port heavier stuff, including the odd NiMH bottle battery now and then. 

My MK1 Ford Ka on the other hand, is considerably low-tech (although even this one gets plugged into a laptop from time to time). After several soggy weeks second guessing that tell-tale bubbling around its fuel-filler cap, a temperate Saturday morning spelt an end to procrastination and hand-wringing.

This is an endemic weak spot (along with sills and tailgates) that can prove expensive, uneconomic if ignored. Moisture gets trapped between the rubberised seal and the recessed section, whereupon it nibbles away unnoticed until those bubbles start brewing. Hardware is easily removed using a Phillips head screwdriver and by this stage; a quick shot of penetrant spray followed by deft taps from rubberised “engineers” mallet.

Fresh out of traditional freeing agents, Effetto Mariposa “Carbo Move”” proved an excellent stand-in and thankfully the damage was less extensive than first feared. Flaking paint and rust dismissed, a quick lick of filler followed by liberal basting of Kurust left curing for the full three hours ensured a sound, primer ready surface.

Three thin coats of high build primer seemed sufficient but wanting to minimise the likelihood of a more squeamish sequel, I slathered some White Lightning crystal grease to the rubberised flange, creating a protective barrier. This technique has proved very effective where rear wiper and tailgate entwine-three years and no recurrence. Reinstating everything prove the most fiddly job, requiring some dexterous juggling and positive energy before it would seat seamlessly within the panel-phew!