Showing posts with label Kinekt stem. Show all posts
Showing posts with label Kinekt stem. Show all posts

Saturday 19 December 2020

Chain Strain







I’ve found it difficult to get inexpensive, yet durable track chains these days. After 1500 miles, the 1/2link KMC is heading on up to the Great Bike Shop in the Sky. I’ve gone for two, another KMC-a Z510 and a Z1X hopefully, it’ll be as faithful, albeit potentially less durable than the Z1 X Inox SEVEN DAY CYCLIST'S 3000 MILE TEST OF A KMC INOX CHAIN The one minor niggle with the latter concerned the inox finish being too slippery, encouraging lubes to migrate from the rollers and to the side plates.  

Tension is a hotly debated topic and for some reason, I’ve found it trickier to get it just-so with ½ link models. I don’t tend to deviate from a 42x15 (ring and sprocket) configuration.  

The Z1X is a traditional single link design, so I had a wander around the web and discovered a chain-link calculator that promised to generate the correct (rounded up) length. (based upon chainstay length, ring, and sprocket size) ...Using said system, the chain for my set up should be 48 links long, which seems ridiculously short.  


Took a guess, using the dead ½ link, pruned and popped aboard. Tension adjusted and track nuts snugged tight, ready for the road again.  Roads are perpetually filthy but thankfully, the gritting lorries have been conspicuous by their absence. 


Post-ride examination of the drivetrain confirmed some minor but tangible play in its UN55 cartridge bottom bracket. I took this opportunity to replace it with a UN300, since the UN55 is seemingly discontinued. 


There’s one waiting in the wings for the Univega, once it’s existing gets the grumbles and a UN26 somewhere, just in case. 


However, while the latter units are solid enough, I’m not particularly taken with the plastic cup. Otherwise, this family is ultra-reliable, fit n’ forget units. So much so, Murphy’s law dictates they will expire when the bike shop’s closed.   


Elsewhere, I decided to add some more lubricant to the Kinekt stem spring and elastomer, using Slip. Slip is vegetable-based, contains no solvent, and therefore, leaves more, composite-friendly lubricant behind.  


Feedback from Kinket’s engineering team suggests this should be the cure for any squeaking/creaking.  I’ve always found elastomer-based systems are low maintenance but run happiest with a moderate helping of synthetic (rubber-friendly) grease. I also found the medium spring can lead to bottoming out on longer road climbs, especially on the fixed (where I’m out of the saddle and placing most of my weight on the bars and pedals). Replacing springs is straightforward but getting the upper spring guide aligned proved trickier with the firmer option. 

   

I’m keeping their seat post clean and protected via larger wedge packs and have switched to an Axiom Grand Fondo, which aside from being super convenient size-wise, offers precisely the surface area to protect the moving components from wet stuff thrown up by the rear wheel.  


I will switch to the dedicated Kinekt model at some point, over Christmas. However, I am interested in testing compatibility with other brands, shapes, and sizes, including bike packing luggage. (Especially given it’s a design that’s also marketed at gravel audiences).  


In common with other suspension posts, including Cane Creek Thudbuster TESTED: CANE CREEK THUDBUSTER ST SEATPOST (sevendaycyclist.com)  there’s an aftermarket boot option to shield moving parts from the elements.  Elsewhere, while unpacking and investigating the storage boxes, I hit the helmet light jackpot, courtesy of this 550lumen Silva Pave’ Front light hailing from 2015. The lightweight, fossil shaped light gives a much purer arc of light than 550 lumens would suggest.