Weighing it Up

 

I'll attribute this to a midwinter lull, but eBay was trying to tempt me into indulging in some surplus stock gravel forks. 4130 throughout, sloping crown, assorted mounts, straight 1/18th steerer and assorted mounts. Clearance for 700x45c... Aside from not NEEDING them, they were raw, so would need painting, which adds to their cost. Being as I would need them powder coated; I'd be closer to £90 by the time everything had been considered.  

 

The fixed gear winter/trainer had a perfectly adequate carbon fork and replacing it (for the admittedly tempting Cro-moly set) would only buy bigger clearance and this wasn't strictly necessary since I'd settled on a more traditional road cum cross typical flavour and 32mm tyres. It would also add some grams. What had I really gained? Sometimes a bargain isn't that when you've weighed everything up- figuratively and literally. 

 

A prudent move too, since the fixed ate another KMC Z1, giving me cause to rethink my policy of running budget chains. Fixed though simple are highly stressed and require closer maintenance than the one cog setup might suggest. The most durable chains I've found to date are the Gusset S-link and KMC X1 stainless. However, both are relatively pricy and in the Gusset's case, hefty. I've decided to go the mid-point route and this Izumi 410.  

 

I'd been out during a particularly wet, grotty morning with various obstacles-looming potholes had my senses screaming with alarm and I was only just able to snatch the front end away at the last second-the gaping chasm would've spat me off, likely into the path of an oncoming vehicle. Composure regained; I cruised the remaining 15 miles at a steady tempo until noting the chain sliding off the rear sprocket and crawling off the front ring. Thankfully, it hadn't jammed but closer inspection revealed it was certainly beyond its prime, signalling imminent replacement. 

 

Waste not, want not...I switched the weary Z1 for one of the YBN that I'd bought for £2, if only to see how durable they were in comparison. Was it a question of having a bargain or getting what I paid for? I wasn't particularly confident, so decided to fit and leave dressed in the factory lube.  

 

Meantime, I've cut the Izumi down to length, so I can just join and adjust when opportunity presents.  I'd be alternating between Ursula and Denise for the coming weeks, depending on whether it was icy, or milder and mucky. Ursula’s KMC began kicking up, which initially had me believing the issue lay with the rear mech’s cable tension, but closer (roadside) inspection revealed splaying of two links, so having completed the ride more gingerly than typical, I switched to a fresh Z10. Presented ideal opportunity to clean out sludgy black stuff from the rear mech, rings and cassette. This was followed by a sudsy bucket deep clean- rid any road salt and similar caustic grot while opportunity presented. 

 

Talking of mucky, Steve was impressed by Portland Design Works Fender Bot PDW Fenderbot Tail Light | cycling-not-racing. As the name suggests, it's a AAA battery powered light affixing to the rear fender (mudguard). Its highly weatherproof, very bright, solidly made and not something an opportunist thief is going to half inch.    

 

Continuing the wintry theme, Robb from Lomo has sent me a pair of their winter gloves. These are a wind and waterproof softshell design with tech friendly rubberised fingers for grip and connectivity with phones and other touch screen devices. There’s a generous Terry thumb wipe, retro-reflective panelling and flat padded palms- no ulnar defending lumps, which can induce precisely the nagging tingling they’re intended to eliminate.    

 

These are a road design and subtle enough for other activities but there’s also a winter mountain bike counterpart. Lomo say these aren’t intended for winter’s most bitter outings. I’ve been out when it’s been close to zero and there was a little nagging chill around the fingertips but this evaporated when the wintry sun brought the mercury to 2 degrees or so.  

 

He's also sent me a pair of Lomo Zephyr panniers that look as if they could give the impressive Oxford Aqua 20 litre a good run for our hard-earned. Reckoned good for everything from soggy commutes to long haul, they’re made from 500denier PVC tarpaulin with RF welded seams and roll top closures. A twin pocket design ensures you can keep things easily segregated. It attaches to racks between 10 and 17mm courtesy of the Rixen Kaul type sprung clips and stabiliser leg. There’s also a webbed strap for easy carrying sans bike.  Right, I’ll close here with my review of the Castelli Espresso Air Jacket Castelli Espresso Air Jacket | cycling-not-racing 

Chopping n’ Changing

 

A brief spell of thaw saw a switch to my fixed gear winter/trainer for some more spirited saunters around the S bends, while saving sensitive derailleur chains from the ravages of gloop, slime, not forgetting the salt monster. After 250miles, it was a filthy fixed, and the Wolf Tooth lube had been licked clean. By this point it received a richly deserved sudsy bucket clean, and the chains gungy side plates were a perfect opportunity to test the Silca Gear wipes.  

These have two sides. A softer one that’s safe on paintwork and similarly delicate surfaces and a grittier, more aggressive texture for cutting through gunk and grime. I was pleasantly surprised by how effectively it stripped the scuzzy chain bare. Obviously, wipes aren’t the most economical way of cleaning drivetrains (or anything else, for that matter) but used sensibly, they can be highly effective and save time- not every change of lube demands the bike(s) get deep cleaned. 

Ordinarily, I’d purge the chain with a degreaser fluid (or bike wash concentrate) before giving the bike a good sudsy bucket wash, typically using a wash n’ wax formula that leaves a protective barrier behind. Foaming blends look more effective, visually, but those which cling to the host surfaces are most effective, breaking the grime down. I’m defaulting to the Peaty’s Link Lube Premium All WeatherPEATY'S LINK LUBE PREMIUM ALL WEATHER | cycling-not-racing across the fleet since its relatively clean and stays put. The temperature tumbled again and momentary temptation to hop on the fixed was immediately tempered by ice.  

Within a few minutes, I was so relieved I’d opted for Ursula. Along the lanes, I spotted a junior road bike- pre/early teen machine, which someone had cut their teeth on and grown out of. It catapulted me back to the spring of 1986 when I picked up my first road bike- a second-hand low rent machine with gas pipe tubing, brush painted in Hammerite by my father.  

Aside from contemporary components and oversized aluminium alloy tubes, the frameset had been repainted in single pack acrylic (rattle can). A relatively tidy job, suggesting some experienced adult guidance. There’s a lot of fun and learning in building a bike from leftover parts. Wonder what they’ve upgraded to...The weather continued to flip flop, and I hopped back aboard the fixed, only to be serenaded by the resplendent and familiar hiss, amplified by flooded roads.  

The WTB ExposureWTB Exposure Road Tubeless Tyre | cycling-not-racing is a supple, quick rolling and engaging tyre but I’ve found it very susceptible to thorns, flints and hedge clippings. A tiny pin prick was easily repaired but I switched to a fresh tube and the 32mm Pirelli Angel DT Urban Pirelli Angel DT Urban Tyre | cycling-not-racing up front.  They’re quicker than their weight and commuter tag might suggest, though the 5mm thick puncture repelling belt has proven very dependable, despite only covering the centre-strip. Reliability is something I prize during the darker months. Aside from the obvious muck, slime and darkness, roads get rougher as the standing water and freezing temperatures cause erosion, holes and similar, which can be rough on rubber.  

I’d also switched the excellent and seemingly bomb-proof Oxford Aqua V20 Single Pannier Oxford Aqua V20 Single Pannier | cycling-not-racing for my 12-year-old Carradice Super C Rack Bag. A classic, seemingly bombproof design which has 13 litres of carrying capacity-ideal for day riding, especially since I’ve got the Oxford Aqua Bar Bag up front.  

Staying with Oxford, they’ve sent me this rather nice Torque R10 mini ratchet. A slight deviation from traditional multi-tools. The wrench is made from 6140 steel, T25 Torx, 2, 2.5, 3, 4, 5, 6 and 8mm bits are made from S2 steel. It also features Chrome Vanadium Steel adapters (1 ¼ sockets and bit) and two nylon tyre levers. The 1 ¼ sockets mean there’s plenty of choice, so you can build a custom toolkit for different bikes/to suit.  S2 steels are shock resistant and apparently, particularly suitable for socket type tools. Primarily a carbon steel alloy, it also features elements of chromium, molybdenum and vanadium.  

It's also used in the Feedback Sports Reflex Torque Bit Driver, which I've become increasingly attached to, these past few weeks. Elsewhere, though the days are getting very slightly longer, lights are still high on the agenda.  

I’ve been sent this Magicshine Allty 400 front Bike Light. Lower output than I’d usually gravitate to. However, thanks to improvements in diodes, lenses and optical quality generally, lumens alone are not the only deciders. My feeling is it will serve me best as a dynamo companion, but real-world miles may say different.